Turntable Installation; Countertop Installation; F) Installation - Brandt SE2616B Manual De Instrucciones

d) Turntable installation
a. Never place the glass tray upside down. The glass tray should never be restricted.
b. Both glass tray and turntable ring assembly must always be used during cooking.
c. All food and containers of food are always placed on the glass tray for cooking.
d. If glass tray or turntable ring assembly cracks or breaks, contact your nearest authorized
service center.
e)

Countertop installation

Remove all packing material and accessories. Examine the oven for any damage such as dents
or broken door. Do not install if oven is damaged.
Cabinet: Remove any protective film found on the microwave oven cabinet surface.
Do not remove the light brown Mica cover that is attached on the right side to the
oven cavity to protect the magnetron.
f) Installation
1. This appliance shall not be placed in a cabinet.
In order to obtain an optimal ventilation of your microwave oven, insert the plastic pin provided
with this instruction manual behind the appliance into the specified hole (Fig 2). Then, place the
appliance against the wall, the optimal ventilation being guaranteed by the plastic pin length.
Leave a minimum clearance of 12 inches (30cm) above the oven, 3 inches (7.5cm) at the left
side and leave the right side open (Fig 1).
Do not remove the legs from the appliance. Do not block airflow outlets, blocking the outlets can
damage your microwave oven.
1. Hub (underside)
2. Glass tray
3. Turntable shaft
4. Turntable ring assembly
39