b) Before Using for the First Time
Before using this juicer for the first time, clean the funnels, filter and receptacle in warm soapy
water. To dismantle the juicer remover the lid and separate the cones by pulling upwards. Do
the same with the receptacle. After cleaning all the parts assemble the juicer following the
dismantling instructions in reverse.
Two juicing funnels of different sizes are supplied with the machine to enable you to juice all
types of citrus fruits as you wish: orange, lemons, grapefruit, etc.
c)
Instructions for Use
After having cleaned all the parts assemble the juicer. Place the receptacle on the motor
unit and insert the filter and the cones on the shaft.
Take the lead out of its compartment by unrolling it and plug the machine in.
Place a glass under the spout.
Lower the spout so that the juice runs into the glass.
Cut the fruit in two and place it on the juicing cone.
Press the fruit gently onto the juicing cone and the juicer will start automatically. The juice
will run into the glass. Use the lid to help press on the fruit.
The juicer stops as soon as the pressure on the cone ceases.
Before removing the glass lift up the spout to ensure that the juice stops running out.
If you are going to extract a large quantity of juice, remove the pulp as it accumulates in
the filter. At the end of the operation dismantle and clean the machine (see "Looking after
and Cleaning your Machine").
3) LOOKING AFTER AND CLEANING YOUR MACHINE
a)
Cleaning Instructions
Unplug and dismantle the machine (see the Chapter "Before Using for the First Time").
Clean the lid, the funnels, the filter and the receptacle immediately after use because dry
pulp is hard to remove.
Wash them in warm soapy water.
The parts of the machine are dishwasher-proof (except the motor unit)
Clean the motor unit with a damp cloth.
You can use a brush to clean the filter.
Never immerse the machine in water or clean it under the tap.
16