Publicidad
Idiomas disponibles
Idiomas disponibles
US
2. AVENT ISIS Breast Pump parts
BOTTLE
PUMP
a)
Funnel cover
h)
Reusable bottle (125 ml/4 oz)
or Disposable Bottle System
b)
Let-down massage cushion
i)
Stand
c)
Pump cover
j)
Dome cap
d)
Silicone diaphragm
and stem*
k)
Newborn nipple (0m+)
e)
Handle
l)
Travel cover
f)
Pump body and funnel
m)
Sealing disc
g)
White star valve*
*spares included
3. To clean and sterilize your pump
Before you use your breast pump for the first
time and every time before use:
Separate all parts, then wash in the top shelf of the
dishwasher or in warm soapy water and rinse. Do not
use antibacterial cleaners/detergents.
Sterilize in an AVENT Steam
Sterilizer (electric or microwave), or by boiling for
10 minutes. If using an AVENT Steam Sterilizer,
the pump will remain sterile in the Sterilizer for 3
hours provided the lid is not removed. Open lid to
dry for storage/assembly. (Always use distilled water.)
4. To keep your pump sterile and
compact for travel
After sterilizing all parts, you can secure the cover (a)
over the funnel and let-down massage cushion and
screw the travel cover (l) onto the pump body (f) in place
of the bottle or bottle holder.
5. Using the AVENT Disposable System
with your ISIS Breast Pump
Simply replace the AVENT Reusable Bottle with
the AVENT Disposable Bottle Holder fitted with
a disposable bottle bag.
6. How to assemble your AVENT
ISIS Breast Pump
Please refer to diagram 6 at the beginning of this leaflet. Separate all
parts and ensure pump has been cleaned and sterilized as in section 3:
1)
Wash your hands thoroughly. Click the white star valve (g) into the
pump body (f) from underneath making sure the flat side of the
valve is downwards and the star side is facing up.
2)
Place the pump body (f) onto the bottle (h).
3)
Twist gently clockwise until it catches. DO NOT OVERTIGHTEN!
4)
Place the silicone diaphragm with stem (d) into the pump body (f).
Make sure it fits securely around the rim by pressing down with
your fingers to ensure a perfect seal. (This is easier if assembled
while wet.)
5)
Place the forked end of the handle (e) under the diaphragm
stem (d) and push down gently on the handle until it clicks
into place.
6)
Carefully insert the let-down massage cushion (b) into the pump funnel
(f) making sure it is perfectly sealed all round the rim of the funnel.
(This is easier if assembled while wet.)
7)
Click the pump cover (c) onto the pump body (f). To make the pump
completely stable insert the bottle into the stand (i).
US
Publicidad
Capítulos
