Adjusting The Blade Guard; Installation; Transportation - Belle Group Minitile 180 Manual Del Operador

GB
The machine is equipped with a continuous diamond rim blade. Even though this blade has been designed
CAUTION
for operator safety if unintentionally touched, pay particular attention to avoid contact between your fi ngers
and the blade during operation of the machine.
MINITILE & MAGIKTILE ONLY!!
Position the blade guard approximately half a centimetre above the tile surface.
Lock the blade guard in position by fully tightening the screw illustrated in the fi gure.
GB
MAXITILE ONLY!!
Remove the machine from the packaging with the aid of the side carrying handles. To set up the machine for work proceed as follows:
1) Remove the leg lock pin and raise the rear side (pump side) of the machine with the handle until the leg is fully extended
(See picture 3a).
2) Raise the leg by sliding it inside the slot.
3) Repeat the operation for the front side of the machine (See picture 3b).
4) Insert the tube-holder rod in its seat (See picture 3c).
GB
MAXITILE ONLY!!
The MAXITILE machine is easy to carry by using the specially provided side handles
(See picture 4).
Before carrying the machine make sure that:
• the motor slide is locked in place with the two cutting adjustment knobs on the slide rail;
• the motor slide is completely lowered and locked with the locking lever;
• the machine is in the 45° (jolly) position and that the inclination adjustment knobs are
properly tightened;
• the tube-holder rod is out of its housing;
• the feet are closed and the leg lock pin inserted.

Adjusting The Blade Guard

Installation

3a

Transportation

3b
8 8
2
3c
4