Operating Instructions - Belle Group Minitile 180 Manual Del Operador

MINITILE & MAGIKTILE ONLY!!
Cutting at 90°
Position the cutting guide and lock it by tightening the knobs fully. (See Figure 5a)
The picture on the right shows how to position hands correctlyduring cutting at 90°. The
forward movement of the piece must be proportional to the blade cutting capacity, to
prevent hazardous fragments that would involve accidents or injuries from breaking off.
Cutting a surface at 45°
Position the tilting table as shown in fi gure 5b, then lock it in place with the knobs.
Position the cutting guide approx. 2 mm from the diamond blade, then lock it in place by
tightening the knobs fully.
Position the tile with the enamel surface downwards; make sure that the diamond blade
does not come into contact with the tile enamel. Adjust the position of the cutting guide
as necessary.
Figure 5b illustrates the correct position of the hands in the case of 45° angle cuts. Note that the right
hand holds the piece in contact with the diamond blade, while the left hand moves the piece forward.
CAUTION
The forward movement of the piece must be proportional to the blade cutting capacity, to prevent
hazardous fragments which would involve accidentsor injuries from breaking off.
MAXITILE ONLY!!
Cutting at 90°
Thanks to the great versatility of the MAXITILE machine it is possible to carry out different
types of cutting.
Adjust the blade to the 0° position with the inclination adjustment knobs (See picture 6a).
Position the piece which needs cutting on the working table and make sure that it is
properly up against the tile-stop. If necessary, a square can be of help.
In order to carry out any diagonal cutting lean the tile against the square the way it is
shown in picture 6b and go on with the cutting operation.
The millimetre ruler placed on the Working table helps only for
CAUTION
linear Cutting.

Operating Instructions

Cutting at 45°
Adjust the blade to the 45° position with the
inclination adjustment knobs (See picture 6b)
Lock the motor carriage at the max. cutting depth with the locking lever. Picture 6c shows
the proper way the machine should be used.
In order to carry out special working it is possible to set out any cutting inclination ranging
6c
from 0° to 45° as marked on the machine side (See picture 6d).
CAUTION
With the MAXITILE machine it is also possible to set out:
a- the cutting length with the cutting adjustment knobs;
b- the cutting depth with the locking lever;
c- the straight cut measurement with the tile bearing square as well as the ruler placed
on the working table;
d- the cutting adjustment with the specially provided indicator and ruler placed on the
6d
slide rail.
Before any cutting make sure that the Tile to be cut is properly
up against The tile-stop.
9
GB
5a
5b
6a
6b