Perel LEDS10DRGB Manual Del Usuario página 6

5. Remote Control Overview
Refer to illustration [B2] on page 3 of this manual.
1 length, dimming and speed setting
2 length of the illuminated section
3 8 constant colours
4 3 colours simultaneously
5 7 colours simultaneously
6 16 colours simultaneously
7 different chase effects
8 shooting stars effect from left to right
9 automatic colour change, fast
10 automatic colour change, slow
11 smooth cycle effect
12 automatic run through all the programmes
13 on/off
14 warm/cold white
6. Installation
Guidelines
 Avoid installing the LED strips near heat sources such as ovens,
toasters, etc.
 Never use the LED strip when it is coiled up as this can cause
overheating.
 Before mounting, ensure the desired surface is flat and clean of
any grease, dirt or debris.
 Avoid tight bends in the LED strip.
 Observe the correct polarity when re-joining cable sections. The
polarity is marked at regular intervals along the LED strip.
 Cut the strip using sharp scissors or a craft knife with a fresh
blade. Cut directly on the marked line. Never cut the LED strip
when it is plugged in.
Installation
Refer to the illustrations on page 2 of this manual.
1. Mount the LED strip in the desired location. The LED strip can be
cut every 10 cm (see [A1]). Protect the cut ends to avoid short-
circuits.
V. 03 – 22/11/2017
LEDS10DRGB
6 ©Velleman nv