Cleaning And Maintenance; Technical Specifications - Toolland DT20016 Manual Del Usuario

 If the material to be sprayed contains sediment, strain the liquid into the sprayer bottle.
 Do not over-pressurize the bottle, or tamper with the pressure release valve.
 After use pay particular attention to the paragraph on cleaning.
 Your sprayer is manufactured from many different types of plastic material, and although the liquid you
wish to use may be packed in a plastic container, this is no guarantee that it will not damage the sprayer. If
you are in any doubt about any chemical you intend to spray we recommend that you contact the consumer
service department at the address given the check its suitability.
9. Troubleshooting
 Too much pressure when operating the pump lever.
Broken or loose rubber washer. Inspect every washer and replace/re-install if necessary.
o
Clogged filter or nozzle. Clean the filter/nozzle.
o
 Low pressure when operating the pump lever.
Dirty rubber washers. Clean all rubber washers with fresh water.
o
 No pressure when operating the pump lever.
Rubber washer is missing. Place a rubber washer.
o
 Jammed pump lever.
The pump is filled with liquid. Remove the pump, empty from the liquid and re-install.
o
10.

Cleaning and Maintenance

 Lubricate all moving parts regularly and replace all worn gaskets.
 Lubricate the pump after every 50 hours of use. To do so:
1. Release the pressure by using the pump lever.
2. Remove the pins and gaskets above and below the pump rod. Remove the pump rod.
3. Hold the pump lever steady. Loosen the pump cap but do not remove. Pull the pump by pulling the
plunger out of its cylinder. Move the plunger to one side to uncover the three gaskets. Lubricate with
silicone oil and proceed in the reverse order to reassemble the pump system.
 Clean the nozzle once a year. Let excess spray fluids drip from the nozzle after each use.
 The lance handle can be disassembled to clean or lubricate the filter. To do so, loosen the back part of the
handle making sure not to lose the inner spring.
 Replace a damaged or worn hose immediately.
 To ensure proper working, make sure the ventilation openings in the filling cap are free at all times. If a
one-way valve gets damaged, please contact your dealer.
11.

Technical Specifications

capacity ................................................................................................................... 16 L
Use this device with original accessories only. Velleman nv cannot be held responsible in the event
of damage or injury resulting from (incorrect) use of this device. For more info concerning this
product and the latest version of this manual, please visit our website www.toolland.eu. The
information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved. No part of this
manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise without the
prior written consent of the copyright holder.
V. 03 – 15/11/2016
DT20016
5 ©Velleman nv