Gardenline 49964 Manual Del Usuario página 7

Pergola
E
E
4
E
Place all five assembled Canopy Supports (E) across the top of the
frame so that they are resting against Crossbeams (C & D). Insert
two Screws M6x65mm (4) through both ends of assembled Canopy
Supports (E) and into Crossbeams (C & D). Tighten all screws that have
been left loose throughout the building process.
12
support@tdcusainc.com
Assembly Instructions
E
E
E
E E
E
E
AFTER SALES SUPPORT
1800 599 8898
USA
USA
Pergola
E
Place Canopy (P) over Canopy Supports (E). Pull Canopy (P) between
Canopy Guide Bar (F) and assembled Crossbeams (B) at either end of
pergola frame.
Run Canopy Weight Bar (G) through sleeves at either end of Canopy
(P). Insert Knobs (N) at either end of Canopy Weight Bar (G) and
tighten.
Tie the strings around each Pole (A) to keep Canopy (P) from swaying
when windy.
Lift Cover (L) up and run four Stakes (O) through designated holes of
Foot (K) and into the ground. Do this with each pole for extra stability.
AFTER SALES SUPPORT
1800 599 8898
USA
P
P
G
N
USA
Assembly Instructions
O
13
support@tdcusainc.com