Resumen de contenidos para Ergotron Neo-Flex Mobile Media Center VHD
Página 1
Neo-Flex Mobile Media Center, VHD & UHD with 90˚ Portrait/Landscape rotation User's Guide Guía del usuario Manuel de l’utilisateur 90˚ M10 x 60mm M5 x 10mm 1x 1x M3 x 37mm M3.5 x 6mm M6x8mm M6x14mm M5x8mm M4 x 16mm Attach Display ATORNILLE MONITOR M4x20mm...
Página 2
WARNING VHD: 50 - 90 lbs (22.7 - 40.8 kg) Stored Energy Hazard: The lift mechanism in the tower is under tension and will move UHD: 90 - 120 lbs up rapidly, on its own, as soon as attached (41 - 54 kg) equipment is removed.
Página 3
15mm M3.5 x 6mm CAUTION: DO NOT overtighten fasteners. Overtightening may cause damage to your equipment. Cuidado:: No sobreapriete los tornilllos, pues podría causar un daño al equipo. Attention: ne forcez pas le serrage de la vis, cela pourrait endommager l’écran et/ou les attaches. 888-24-064-M-00 rev.
Página 4
M3 x 37mm 888-24-064-M-00 rev. B • 12/08 4/14...
Página 5
M6x14mm M6x8mm 200 mm M5 x 10mm 200 mm 400 mm 400 mm 600 mm 600 mm 888-24-064-M-00 rev. B • 12/08 5/14...
Página 6
If a stand is already attached to your display, Si el monitor incorpora una peana sobremesa, Si l’écran dispose déjà d’un pied, ôtez ce dernier remove it according to display manufacturer extraiga la misma siguiendo las instrucciones de su en suivant les recommandations du fabricant puis directions.
Página 7
Ø Hole Diameter DIAMETRO DE LOS ORIFICIOS DIAMETRE DES TROUS: 4 tailles de vis Four sets of display bracket screws have been Se incluyen 4 juegos de tornillos para el soporte sont fournies pour monter les étriers : 4mm, provided, each of a different diameter: 4mm, del monitor, con diferentes diámetros: 4mm, 5mm, 6mm et 8mm.
Página 8
Compare this measurement Compare esta medida Comparez cette mesure Compare this measurement to the recom- Compare esta medida con el tornillo recomen- Comparez cette mesure avec la taille des vis re- mended screw (based on display back type and dado (basado en el tipo de cubierta trasera y commandée (en fonction du diamètre des trous diameter), taking into consideration the need for el diámetro de los orifi...
Página 9
Si nota vis ne convient, contactez Ergotron. Si la to see if a screw with a better matching size resistencia, extraiga el tornillo y compruebe si combinaison des attaches est bonne, montez les has been provided.
Página 10
Arriba Haut x < 600mm ATTACH BRACKETS TO DISPLAY ATORNILLE LOS SOPORTES FIXER LES ETRIERS A L’ECRAN DE MONTAJE AL MONITOR Place Display Brackets (with pre-determined Montez les étriers (avec les attaches adaptées) fasteners) on back of display: Coloque los soportes de montaje en la cubi- au dos de l’écran.
Página 11
M4 x 16mm It is important that you adjust this product according to the weight of the mounted equipment as described in the following steps. Any time equipment is added or removed from this product, resulting in a change in the weight of the mounted load, you should repeat these adjustment steps to ensure safe and optimum operation.
Página 12
90˚ 888-24-064-M-00 rev. B • 12/08 12/14...
Página 13
M5x8mm NOTE: Leave enough slack in cables to allow full range of motion. No deje el cable excesivamente tenso Laisser du mou dans le câble 888-24-064-M-00 rev. B • 12/08 13/14...
Página 14
DO NOT route electric cords or possible hazards. Only equipment cables within reach of Ergotron-approved installers may children. LOCK CASTERS when Cart is service or otherwise modify cart/stand. Failure to heed this stationary. Failure to comply with this...