Safety; Cleaning And Maintenance; Storage - Vermeiren PEPI Manual De Instrucciones

SAFETY

L
The PEPI bath deckchair is a therapeutical device and should be used under supervision!
L
Use this deckchair only on flat and even surfaces!

CLEANING AND MAINTENANCE

In order to retain the proper aesthetic value of your product, it is necessary to ensure its proper
maintenance. The following guidelines will be useful for the fulfilment of this aim.
Upholstery
Upholstery is removed and can be washed in washing machines (at a maximum temperature of 60°C).
Washing in sheaths or cloths is recommended.
L
In case of strong contamination, clean manually with the use of soft detergents.
L
Do not clean updholstery with very strong detergents, such as solvent or caustic agents; use
of hard brushes is not recommended, either.
L
We are not responsible for any damages arising after the use of improper detergents.
L
Jet-steam cleaning is not recommended.
Plastic elements
Such details should be cleaned manually with generally available products upon reading of the
guidelines of the manufacturer of such product.
External coating
The applied anodic coat is important due to its high aesthetic value and anti-corrosive properties.
These coats do not require special cleaning (it is sufficient to wipe them with a damp or dry cloth).
Disinfection
Disinfection can be performed with the use of generally available products upon reading of the
instructions of the manufacturer of such product. Please remember that they may penetrate into the
upholstery.
L
During the disinfection, use protective gloves and follow the instructions of the manufacturer of
such product.
L
The manufacturer of the product being disinfected is not responsible for any consequences of
improper use of disinfectants.

STORAGE

Store in a dry place (between + 5 °C and + 45 °C).
•
The relative humidity of the air should be between 30% and 70%.
•
Ensure there is protection against corrosion (e.g. salt water, sea air, sand, dust) by providing
•
sufficient covering or packaging.
Store all removed parts together in one place (or mark them if necessary) to avoid mixing up
•
with other products when re-assembling.
No component must be stored with a heavy weight on it.
•
4
E
PEPI
04/2010