Important Instructions - Twin-Star International 24FI061ARU Manual De Instrucciones

electrical shock, and injury to persons including the following:
1. Read all instructions before using this appliance.
do not let bare skin touch hot surfaces. If provid-
ed, use handles when moving this appliance.
Keep combustible materials, such as furniture,
pillows, bedding, papers, clothes and curtains at
least 3 feet (0.9 m) from the front of this appliance.
and unattended, extreme caution is necessary if
children or invalids are nearby.
4. If possible, always unplug this appliance when
not in use.
5. Do not operate any heater with a damaged cord or
has been dropped or damaged in any manner.
servicing must be replaced prior to operating
8. Do not use outdoors.
laundry areas and similar indoor locations.
Never locate this appliance where it may fall into
a bathtub or other water container.
10. Do not run cord under carpeting. Do not cover
cord with throw rugs, runners or the like. Arrange
be tripped over.
11 . To disconnect this appliance, turn controls to
12. Connect to properly grounded outlets only.
cally grounded in accordance with local codes
of local
CSA C22.1 Canadian Electrical Code or for U.S.A.
installations, follow local codes and the National
Electrical Code, ANSI/NFPA NO. 70.
14. Do not insert or allow foreign objects to enter any
ventilation or exhaust opening as this may cause
intakes or exhaust in any manner. Do not use
become blocked.
16. ere is a thermostat limiter inside the heater.
When the inner temperature over heating or occur
abnormal heating, the thermostat protective device

IMPORTANT INSTRUCTIONS

would cut o power supply to avoid the rplace
damaged or risk of re.
17.
a socket-outlet.
18.
parts inside. Do not use it in areas where gasoline,
for clothing. Christmas stockings or decorations
should not be hung in the area of it.
19. Use this appliance only as described in the
manual. Any other use not recommended by the
injury to persons.
20. Avoid the use of an extension cord because the
extension cord may overheat and cause a risk of
the cord must be No. 14 AWG minimum size and
must be a three wire cord with grounding type
shall not be more than 20 feet in length.
21. See Figure 1 for the grounding instruction.
a plug as shown at A. An adapter as shown at C
is available for connecting three-blade grounding
grounding plug extending from the adapter must
be connected to a permanent ground such as a
not be used if a three-slot grounded receptacle is
available.
GROUNDING PIN
ADAPTER
GROUNDING
MEANS
SAVE THESE INSTRUCTIONS
E-2
Figure 1
COVER OF GROUNDED
OUTLET BOX
METAL SCREW
A B
C D
GROUNDING PIN