Remote Control; Power Source - memorex MVD4541 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

÷
Remote control / Power source
inserting
Batteries
1
Open the battery
2
Install two 'AAA" batteries
(not
3
Replace the compartment
compartment
cover in the
supplied),
paying
attention
to the
cover.
direction
of the arrow,
polarity
diagram
in the battery
compartment.
Battery precautions
The precautions below should be fottowed when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment.
Reversed
batteries may cause damage to the device. To avoid a potential short circuit, insert the "- end first.
3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh ones.
4. tf the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible
battery leakage.
5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture (Follow battery manufactur-
er's directions).
÷
Remote control
basics
• Press POWER to turn the DVD/VCR on or off.
• Press CH ^ or CH v to move through the channels one channet at a time.
• The CH A!V
and SET +l= are also used to navigate on=screen menu system.
• You can directly access specific channels using Number keys pad.
• Each press of VCRIDVD on the remote control, switches the screen between the VCR screen (VCR mode) and the DVD
screen (DVD mode).
÷
Operation
• Aim the remote control at the remote sensor and press control buttons to operate.
• Operate the remote control within 30: angle on either side of the remote sensor,
up to a distance of Approx. 5 meters.
Y
Power
source
To use AC POWER SOURCE
AC Outlet
Wider Hote
_:::_=:::_
Polarized AC Cord Plug
(One blade is wider than the other.)
Use the AC polarized line cord provided for operation on AC. insert the AC
cord ptug into a standard 120V 60Hz polarized AC outlet.
NOTES:
• Never connect the AC line cord plug to other than the specified
voltage (120V 60Hz). Use the attached power cord only.
• If the polarized AC cord does not fit into a non=polarized AC
outtet, do not attempt to file or cut the blade, tt is the user's
responsibility
to have an electrician replace the obsolete outlet.
• If you cause a static discharge when touching the unit and the
unit fails to function, simply unplug the unit from the AC outlet
and ptug it back in. The unit should return to normal operation.
9
2F3P421A[E](06-09)
÷
1/25/05, 12:01 PM

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido