Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
UNPACKING
This product requires assembly.
Carefully remove the product and any accessories from the box.
Make sure that all items listed in the packing list are included.
Inspect the product carefully to make sure no breakage or damage
occurred during shipping.
Do not discard the packing material until you have carefully inspected
and satisfactorily operated the product.
PACKING LIST
Hedge Trimmer Cutting Head
Blade Cover - Telescopic Pole w/Shoulder Strap - Rear Han-
dle - Instruction Manual
WARNING: If any parts are damaged or missing do not operate this
product until the parts are replaced. Failure to heed this warning
could result in serious personal injury.
If any parts are damaged or missing, please call 1-800-313-5111 for
assistance.
CONVERTING FROM HEDGE TRIMMER TO POLE HEDGE
TRIMMER
1.
Lift the quick release button. Pull to remove the handle from the
cutting head. (Fig. 1)
Quick Release
Button
Rear
handle
2.
Insert the telescopic pole into the hedge trimmer cutting head.
(Fig. 2) Press the quick release button into a locked position.
Quick Release
Button
Pole
3.
Insert the rear handle into the end of telescopic handle. (Fig. 3)
Press down the quick release button. Ensure the release button
snaps firmly into position to lock the handle securely.
Quick Release
Button
Rear
Handle
ASSEMBLY
CONVERTING FROM POLE HEDGE TRIMMER TO HEDGE
TRIMMER
1.
Disconnect rear handle and cutting head from ends of
telescopic pole by lifting the quick release button and pulling
straight out. (Fig. 4-5)
2.
Insert the rear handle directly into the chainsaw cutting head .
When fully inserted, press down the quick release button.
Make sure the button snaps in firmly and securely, locking the
parts together.
FIG.4
ADJUSTING THE LENGTH OF THE TELESCOPIC POLE (FIG.6)
1. To adjust the telescopic pole, disconnect the product from
the power supply. Rotate the collar counterclockwise to
loosen.Extend the pole to the desired length.
NOTE: Only extend the pole to minimum length required to
reach the limb or shrub to be cut.
2.
Lock the pole in position by turning the collar clockwise
firmly to secure.
WARNING: Failure to lock the telescopic pole collars as directed
could result in personal injury.
FIG. 1
FIG.6
Locking
Collar
CAUTION:Do not use this product while on a ladder or scaffold.
FIG. 2
NEVER ALLOW CHILDREN TO OPERATE HEDGE TRIMMER/
POLE HEDGE TRIMMER.
FIG.3
4
FIG.5
Publicidad
Tabla de contenido
