Threading The Upperthread - SOLAC SW8220 Instrucciones De Uso

DESCRIPTION
A Tension disk
B Upper thread spindle
C Thread cap
D Upper thread
E Under threas winding shaft
F Stop poling
G Hand wheel
K Presser foot filter
H Reverse lever
I On/off/ velocity/ pedal switch
J Free arm
K Light
L Pattern selection dial
M Upper thread tension dial
N Take-up lever
O Grip
P Thread cutter
Q Thread guide
R Presser foot lock lever
S Presser foot
T Feet doc bobbin case lid
U Needle clamp screw
W Bobbin case lid release button
X Presser foot filter
Y Adaptor socket
Z Food pedal socket
A.A Foot pedal
A.B Adaptor
A.C Buttonhole,Threader, Needle, Spoot x2, Bobbin x3
If the model of your appliance does not have the accessories described
above, they can also be bought separately from the Technical Assis-
tance Service.

THREADING THE UPPERTHREAD

- Replace the thread as follows when you run out of thread or if you
want to change thread colour.
1. Remove the thread cap, place a spool of sewing machine thread on
the spindle, and place the thread cap.
2. Place the thread through the thread tension disk and pass the thread
through the groove.
3. Pass the thread through the upper thread guides.
4. Hang into the take-up lever from right to left When the take-up lever is
in its highest position.
5. Hang the thread into the thread into the thread guide from left to right.
6. Rotate the hand wheel to raise the needle to its highest position and
pass the thread through the eye of the needle from the front to the back.
Use of the needle threader
1. Pass the tip of the needle threader through the eye of the needle from
the rear of the machine to the front.
2. Pass the thread through the ring.
3. Gently pull on the needle threader to pass the thread through the eye
of the needle from the front toward therear.
THREAD THEBOBBINTHREAD
- Thread the upper thread before threading the bobbin thread. You will
not be able to bring up the bobbin thread unless you have already
threaded the upper thread.
- CAUTION: Be sure to use metalbobbins.
1. Rotate the hand wheel toward you (counter clockwise) to raise the
needle to its highest position. Lift the presser foot lifter.
2. Push the hook cover plate release button to remove it.