Instructions Of Use; Installing The Batteries - SOLAC SW8220 Instrucciones De Uso

- Increase the number of the upper thread tension dial.
- Turn the upper thread tension dial down to increase the
number until the stitches become normal and the upper
thread tension is tight.
The upper thread should appear straight
Upper thread is too tight
- Reduce the number on the upper thread tension dial.
- Slowly turn the upper thread tension dial up to reduce
the number until the stitches become normal and the
upper thread tension isreduced.

INSTRUCTIONS OF USE

- Make sure that all the product's packaging has been removed.
- Some parts of the appliance have been lightly greased. Consequently,
the first time the appliance is used a light smoke may be detected.
After a short time, this smoke will disappear.
- Prepare the appliance according to the function you wish to use:
- This device can be mains or battery operated.
- Note: If you want to operate machine on batteries, unplug the adapter
from the mains and then from the sewing machine.

INSTALLING THE BATTERIES:

- Caution: During the handling of batteries, do not touch both poles at
the same time, as this will provoke the partial discharge of the stocked
energy therefore affecting longevity.
- Check that the plastic covering that protects the battery has been
removed (some batteries are sold with a protective covering)
- It is essential that the batteries should always be the same kind and
the same charge. Never mix alkaline batteries with normal one (Car-
bon-Zinc) and/or rechargeable ones.
- Do not combine new batteries with older batteries, and not reverse the
polarity.
- To stop the machine from starting when fitting the batteries, use one of
the following options:
- Plug the adapter into the machine but not into the mains power
socket.
- Set the speed switch to the "FOOT PEDAL" position.
- Tilt the sewing machine on its side and remove the cover of the battery
compartment on the bottom.
alkaline batteries (LR6). Only use new batteries.
- Make sure the batteries are correctly oriented.
- Then close the cover.
- Remove the batterie if you will not be using the machine for long peri-
od of time. Batteries left in the machine may leak.
- NOTE: machine light will be always on if batteries are placed on the
appliance.
USING THE FOOT PEDAL AND ADAPTOR
- Connect the foot pedal by inserting the jack into the foot pedal input
socket. Then you can use the foot pedal turn on the machine instead
of using the hand switch (Power off and speed switch), so it's easy
and convenient.
- Connect the adaptor's jack to the DC input socket (?) on the back of
the machine and connect the plug to the main power supply.
Insert four AA
3