Operating Engine - SMASH 16 Manual De Instrucciones

OPERATING ENGINE

( I ) ( O ) A – FILLING FUEL
Fill fuel and chain oil tanks respectively,
1
and tighten the caps securely.
B – STARTING A COLD ENGINE
1. Move the switch to the ("I") position. (Fig.1)
2. Press the bulb primer a few times until you
3. Pull out the air lever to the closed position
4. While holding the saw unit securely on the
2
3
5.When the engine makes a first attempt to
6. One the chainsaw is on, allow the engine to
Mantenga limpia y alejada de obstáculos la cadena de
4 la motosierra, ya que empezará a girar al arrancar el
motor.
notice a sligth pressure. (aprox. 5 times)
(Fig.2)
(A). The shutter will close and the throttle
lever will remain accelerated. (Fig.3)
ground, pull the starter rope vigorously.
(Fig.4)
Do not start the engine while holding the chain saw
with a hand. The saw chain may touch your body. It's
very dangerous.
start, push in the air level to its original
position (B) (normal work position). If the
engine does not start, pull the starting rope
again until the engine starts. (Fig.3)
run at high speed for a few seconds. Then
release the accelerator by pressing the
accelerator trigger, leaving the chainsaw at
idle speed.
61