Control Panel Operation; Temperature Adjustment (80°F-104°F/26°C-40°C); Jets Operation; Multi Color Led Light - AquaTerra Montecito Manual De Uso

INITIAL START-UP -
Startup Mode. Different codes will display on the screen. Once Startup Mode completes, the
actual temperature is displayed on
the screen, and the spa will then
begin to heat and maintain the
water temperature and the first filter
cycle will start. Your spa has been
designed so that it will automatically
heat the water to the factory set
temperature of 100°F unless you set
the spa to a different temperature. If
power is disconnected from the spa,
it will automatically revert back to the
last saved set temperature when power is reapplied.
TEMPERATURE ADJUSTMENT (80°F-104°F/26.5°C-40°C)
The temperature can only function between 80°F - 104°F / 26.5°C - 40°C. The last measured
temperature will constantly display on LCD.
Press the Plus or Minus buttons to display the set temperature and indicator
button is pressed again, the set temperature will increase or decrease depending on which button
is pressed. After five seconds, the LCD will automatically display the current spa temperature.
The "heater" indicator
more heat, but the heater is not on. Once set temperature is reached the indicator
the low speed of the jet pump turns off after 30 seconds (if not in filter cycle).

JETS OPERATION

Firmly press the Jets button once to activate the low speed of the pump and again for the high
speed. Firmly press the Jets button again to turn off the pump. If left running the low or high speed
pump will automatically turn off after 1 hour. The "Jets" indicator light next to the button will blink
when jet pump is on low speed and is solid on high speed.

MULTI COLOR LED LIGHT

Press the Light button once to turn on the light, the light indicator next to the button is lit when
the light is on. Press the button again to turn the light off. Every time the light is quickly turned off
and on a new light mode will appear. The sequence is as follows: White, Slow Full color wheel,
Amber, Blue, Red, Green, Purple, Blue/Green color wheel, Red/Green color wheel and Fast Full
color wheel. The last light mode used will come back on when the light is turned off for more than
2 seconds.
NOTE: If left on, the light will automatically turn off after 4 hours of operation.

FILTER CYCLES

There are two filter cycles: the first cycle (F1) starts right after power up and the second cycle (F2)
will start 12 hours later. The default duration for the first filter cycle is 1 hour, and 30 minutes for
the second cycle. Filter cycles only run at low speed. The "Filter" indicator
filter cycle is on. The duration of each filter cycle can be modified.

CONTROL PANEL OPERATION

When the spa is first powered up the control system begins a 2 minute
lights up when the heater is on. It flashes when there is a request for
Indicator Lights
Jets Light
11
Temp Temp
Plus Minus
. Each time either
shuts off and
lights up when a