Assembly - Dremel 220 Manual De Usuario

Safety Rulesfor Drill
This Drill Press was designed for drilling,
sanding, brushing, polishing or grinding
applications, other applications may present
hazards that cannot be adequately guarded.
If the side of any rotating accessory is used
to perform the work, for example a sanding
drum, the workpiece must be positioned on
the side of the accessory that rotates against
the feed direction of the workpiece. Placing
the workpiece on the side of the accessory
where the feed direction and accessory
rotation are same may cause the workpiece
to be pulled by the rotating accessory and
lead to loss of control during operation.
Never start the tool when the bit is
engaged in the material. The bit cutting
edge may grab the material causing loss of
control of the workpiece.
Do not reach in the area of the spinning
bit. The proximity of the spinning bit to your
hand may not always be obvious. Workpiece
could shift or your hand could slip during
operation.
Some dust created by
power sanding, sawing,
grinding, drilling, and other construction
activities contains chemicals known to
cause cancer, birth defects and other
reproductive harm. Some examples of
these chemicals are:
Press (continued)
• Lead from lead-based paints,
• Crystalline silica from bricks and cement
and other masonry products, and
• Arsenic and chromium from chemically-
treated lumber.
After changing the bits or making any
adjustments, make sure the collet nut and
any other adjustment devices are secure-
ly tightened. Loose adjustment device can
unexpectedly shift, causing loss of control,
loose rotating components will be violently
thrown.
Never touch the bit during or immediately
after the use. Contact with a spinning bit will
cause injury and after use the bit is too hot to
be touched by bare hands.
Do not leave a running tooling unattend-
ed, turn power off. Only when tool comes
to a complete stop it is safe to remove work-
piece and clean the stand.
THINK SAFETY! Safety is a combination of
operator COMMON SENSE and ALERT-
NESS at all times when the tool is being
used.
Use only grinding wheels, sanding
disks/drums and drill bits when using the tool
in the Work Station and any other accessory
will cause injury to the user.
Assembly
ATTACHMENT FOR USE WITH DREMEL
ROTARY MODELS 275, 285, 295, 300,395,
398, 400, 780 AND 800.
ATTENTION: Read this entire instruction
manual carefully before using your Dremel
Workstation, Retain instructions for future
reference. Your Dremel Workstation 220 will
convert rotary tools to a drill press for drilling,
to a tool holder for sanding or polishing, or to
a flex shaft tool stand,
1. Assemble the tube to the base and
secure with hex bolt and square nut.
4,
5.
6.
2. Insert the square nut (short end first)
into the tube support assembly and
install the height adjustment lever. Slide
the press onto the larger section of the
tube and tighten.
3. Install the crow's nest onto the larger
section of the tube with small holes
facing up.
Install the cord holder.
Install the hanger wire and cap.
If desired, base may be secured to a
workbench using the appropriate size
hardware (not supplied).