Straight Cuts; Diagonal Cuts; Plunge Cuts; Bevel/Miter Cuts - Brutus 61024BR Instrucciones De Funcionamiento

STRAIGhT CUTS

STEP 1: Adjust the rip guide to 90°and position it the
desired distance from the blade.
STEP 2: Position the material to be cut against the rip
guide and back measurement rail.
STEP 3: Loosen the slide tube locking knob (FIGURE 17).
STEP 4: Make a straight cut by pushing the cutting
table toward the cutting head (FIGURE 18).
FIGURE 17
Rip
guide
FIGURE 18

DIAGONAL CUTS

STEP 1: Adjust the rip guide to 45° and position it at
the desired distance from the blade.
STEP 2: Position the material to be cut against the rip
guide and back measurement rail.
STEP 3: Loosen the slide tube locking knob (FIGURE 17).
STEP 4: Make a diagonal cut by pushing the cutting
table toward the cutting head (FIGURE 19).
Rip
guide
FIGURE 19
Slide tube
locking knob

PLUNGE CUTS

ADJUSTING THE TILE SAW MOTOR HEAD FOR PLUNGE
CUTS OR BEVEL CUTS.
STEP 1: Turn off the power.
STEP 2: Position the material to be cut against the rip
guide and back measurement rail.
STEP 3: Loosen the slide tube locking knob (FIGURE 17).
STEP 4: Loosen the motor head adjustment lever on the
spring support (FIGURE 16), to release the cutting head.
STEP 5: Bring motor head to the highest position.
STEP 6: Push the cutting table to the desired position
where the blade is over the tile at the point you want to
start the cut-out.
STEP 7: Tighten the slide tube locking knob to a fixed
table position.
STEP 8: Turn the saw on.
STEP 9: Slowly push the blade down into the tile to
achieve the plunge internal cut you desire (FIGURE 20).
STEP 10: After each cut, turn the motor off and turn
the position of the tile to achieve rectangle or square
cut-outs.
Rip
guide
FIGURE 20

BEvEL/MITER CUTS

THREE POSITIONS (0°, 22.5 °OR 45°). ANY OTHER
BEVEL CUT WILL DAMAGE THE WORK TABLE.
STEP 1: Turn off the power.
STEP 2: Position the cutting table in its farthest back
position and lock with slide tube locking knob
(FIGURE 17).
STEP 3: Loosen the bevel adjustable knob on the bevel
support arm (FIGURE 21), found at the back of the motor
head, to adjust the guide by tilting the head (FIGURE 22)
to 22.5° or 45°angle. Make sure the blade aligns with
the angle slot provided on the cutting table.
– 9 –
TURN OFF THE POWER BEFORE
THE SAW IS ADJUSTABLE TO