California Proposition 65; Electrical Requirements; Wiring Diagram - Brutus 61024BR Instrucciones De Funcionamiento

CALIFORNIA PROPOSITION 65

POWER SANDING, SAWING, GRINDING, DRILLING
AND OTHER CONSTRUCTION ACTIVITIES CONTAIN
CHEMICALS KNOWN TO THE STATE OF CALIFORNIA
TO CAUSE CANCER, BIRTH DEFECTS OR OTHER
REPRODUCTIVE HARM.
Some examples of these chemicals are:
• Lead from lead-based paints,
• Crystalline silica from bricks and cement and other
masonry products, and,
• Arsenic and chromium from chemically-treated
lumber.
Your risk from these exposures varies, depending on
how often you do this type of work. To reduce your
exposure to these chemicals: work in well ventilated
area, and work with approved safety equipment, such
as those dust masks that are specifically designed to
filter out microscopic particles.

ELECTRICAL REQUIREMENTS

1. THIS TILE SAW MUST BE CONNECTED TO A
GROUNDED POWER SOURCE while in use to
protect the operator from electrical shock.
2. IN THE EVENT OF A MALFUNCTION OR
BREAKDOWN, grounding provides a path of least
resistance for electrical current to reduce the
risk of electrical shock. This tool is equipped with
an electric cord having equipment grounding
conductor and a grounding plug. Insert the 3-prong
electrical plug into a 3-pole receptacle that is

WIRING DIAGRAM

Ground
to motor
frame
FIGURE 2
SOME DUST CREATED BY
Green
Capacitor
Black
Overcurrent
breaker
properly installed and grounded in accordance
with all local codes and ordinances.
3. DO NOT MODIFY THE PLUG provided if it will not
fit the outlet. Have the proper outlet installed by a
qualified electrician.
4. IMPROPER CONNECTION OF THE EqUIPMENT-
GROUNDING CONDUCTOR CAN RESULT IN A
RISK OF ELECTRIC SHOCK. The conductor with
insulation having an outer surface that is green
(with or without yellow stripes) is the equipment-
grounding conductor. If repair or replacement
of the electric cord or plug in necessary, do not
connect the equipment-grounding conductor to a
live terminal.
5. CHECK WITH A qUALIFIED ELECTRICIAN or
service personnel if the grounding instructions
are not completely understood, or if in doubt as to
whether the tool is properly grounded.
6. USE ONLY 3-WIRE EXTENSION CORDS that have
3-prong grounding plugs and 3-pole receptacles
that accept the tool's plug.
7. REPAIR OR REPLACE DAMAGED OR WORN
CORD IMMEDIATELY.
8. To avoid the possibility of the appliance plug or
receptacle getting wet, POSITION TILE SAW TO
ONE SIDE OF A WALL-MOUNTED RECEPTACLE
TO PREVENT WATER FROM DRIPPING ONTO THE
RECEPTACLE OR PLUG. The user should arrange
a "drip loop" in the cord connecting the saw to a
receptacle. The "drip loop" is that part of the cord
below the level of the receptacle, or the connector
if an extension cord is used, to prevent water
traveling along the cord and coming in contact
with the receptacle.
Motor
White
Black
Interruptor
– 3 –
Green
White
Black