Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
KPS-MT30 • Digital multimeter
1.
INTRODUCTION
The meter is a handheld 31/2 digital multimeter for measuring DC and AC voltage,
DC current, Resistance, Diode, Transistor and Continuity Test with battery operated.
2.
FRONT PANEL
(1)
Display. 3 1/2 digit, 7 segment, 15mm high LCD.
(2)
Rotary switch. This switch is used to select functions and desired ranges as
well as to turn on/off the meter.
(3)
"V ΩmA" jack. Plug in connector for red (positive) test lead for voltage, resist-
ance and current (except 10A) measurements.
(4)
"COM" jack. Plug in connector for black (negative) test lead.
(5)
"10A" jack. Plug in connector for red test lead for 10A measurement.
(6)
Hold button. When this button is pushed, the display will keep the last reading
and "H" symbol will appear on the LCD until pushing it again.
3.
SAFETY INFORMATION
This multimeter KPS-MT30 has been designed according to IEC 61010 concerning
electronic measuring instruments with an overvoltage category (CAT.III 600V) and
pollution grade 2. Follow all safety and operating instructions to ensure that the
meter is used safely and is kept in good operating condition.
4.
SAFETY SYMBOLS
Symbol
Meaning
Important safety information, refer to the operating manual.
Dangerous voltage may be present.
Double insulation (Protection class II).
Earth ground.
9
Publicidad
Tabla de contenido
