AFG Sport 3.5AE Manual Del Propietário página 8

ASSEMBLY STEP 3
CONSOLE MAST
CONSOLE CABLE
PRE-INSTALLED BOLTS
AND WASHERS
MAIN FRAME
NOTE: Be
careful not
to pinch any
wires while
attaching the
console mast.
GUIDE RAIL
PEDAL ARM WHEEL
8
CRANK
PEDAL ARM
WAVY WASHER (G)
FLAT WASHER (H)
SPRING WASHER (I)
BOLT (J)
HARDWARE BAG 3 CONTENTS :
WAVY FLAT
WASHER (G) WASHER (H)
22.5 mm 20 mm
Qty: 2 Qty: 2
Open HARDWARE BAG 3.
A
Carefully pull the CONSOLE CABLE through
B
the CONSOLE MAST using the twist tie
located inside the CONSOLE MAST.
Attach CONSOLE MAST to MAIN FRAME
C
using PRE-INSTALLED BOLTS AND
WASHERS.
Slide WAVY WASHER (G) over CRANK
D
followed by PEDAL ARM as shown. Rest
PEDAL ARM WHEEL on GUIDE RAIL.
Attach the PEDAL ARM to the CRANK using 1
E
FLAT WASHER (H), 1 SPRING WASHER (I)
and 1 BOLT (J).
Repeat steps D–E on the opposite side of the
F
elliptical.
SPRING
BOLT (J)
WASHER (I)
20 mm
15 mm
Qty: 2
Qty: 2