Skil CS4555-00 Manual Del Propietário página 8

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Aggressive or abusive cutting or misuse
of the chain saw can cause premature bar,
chain, and/or sprocket wear, as well as a
broken chain or bar, leading to kickback,
chain throw or the ejection of material .
Never use the guide bar as a lever . A bent
guide bar can cause premature bar, chain, and/
or sprocket wear, as well as a broken chain
or bar, leading to kickback, chain throw or the
ejection of material.
Cut only one work piece at a time .
Push and Pull – The reaction force is always
opposite to the direction the chain is moving
where wood contact is made. Thus, the
operator must be ready to control the PULL
when cutting on the bottom edge of the bar,
and the PUSH when cutting along the top
edge. See Figure 6.
Plan the work, ensuring an obstacle-free
work area and, in the case of felling, at least
one escape path from the falling tree .
When felling, keep bystanders at least two
tree lengths away .
Use only with the battery packs and
chargers listed below:
Battery
BY8705-00
BY8708-00
Do not charge the battery pack in rain or in wet locations .
Do not expose a battery pack or tool to fire or excessive temperature. Exposure to fire or
temperature above 212 °F (100°C) may cause explosion.
If situations occur which are not covered in this manual, use care and good judgment .
Contact SKIL Customer Service for assistance .
8
Charger
SC5364-00
SAVE THESE INSTRUCTIONS!
Fig. 6
PULL
PUSH

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido