MRA 10896 Instrucciones De Montaje página 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA screen
2 Countersunk Allen screws, M6 x
30mm
2 Spacers, 25x16.5x10 mm
2 Spacers, 15x6.3x10 mm
How to mount the screen onto your motorbike:
1. Stand your motorbike up on a level surface.
2. Insert the rubber grommets from the original screen into your MRA screen (P2).
3. Place the two larger spacers onto the lower mounting points (P3).
4. Position the MRA screen; fasten the upper part using the original screws, and the
lower part using the M6 x 30 screws and smaller spacers (P4).
5. Mount the edge protection strip included onto the screen. Slide the end sleeves over
the end of the edge protection strip, and secure it by gently crimping the sleeves with
a pair of pliers.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
Aprilia Caponord
Article No..
--- Allen key 4 mm
10896
10894
10895
2
Required tools