Maintenance; Scheduled Maintenance Table; Battery Charger Cable Check - KENT Edge 28B Instrucciones De Uso

ENGLISH

MAINTENANCE

The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
The following table provides the scheduled maintenance. The intervals shown may vary according to particular working
conditions, which are to be defi ned by the person in charge of the maintenance.
WARNING!
To carry out maintenance procedures, the machine must be off and, if necessary, the batteries must be
disconnected.
Moreover, carefully read the instructions in the Safety paragraph.
All scheduled or extraordinary maintenance procedures must be performed by qualifi ed personnel, or by an authorised Service
Center.
This Manual describes only the easiest and most common maintenance procedures.
NOTE
For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that can
be consulted at any Service Center.

SCHEDULED MAINTENANCE TABLE

Procedure

Battery charger cable check

Side and main broom height check and adjustment
Skirt height and operation check
Dust fi lter cleaning and integrity check
Hopper gasket check
Filter shaker operation check
Drive belt and clutch visual inspection
Drive system belt tensioner adjustment
Nut and screw tightening check
Motor carbon brush check or replacement
(*): For the relevant procedure, see the Service Manual.
(1): And after the fi rst 8 hours.
BATTERY CHARGER CABLE CHECK
Carefully check the battery charger cable (18) and the relevant plug for wear, cuts, cracks or other damages.
If the battery charger cable or the relevant plug is damaged, contact the Kent Service Center.
12
INSTRUCTIONS FOR USE
146 3082 000(2)2007-06
Every 10 Every 50
hours hours
Edge 28B
Every 200 Every 400
hours hours
(*)
(*)
(*)
(*) (1)
(*)