Miniland digimonitor 3.5" Manual De Instrucciones página 20

· Then Turn ON the NEW Camera. Press and hold the hidden SYNCHRONIZATION button
(10) through the small hole at the back of the Camera using a pin. The Power LED Light will
start flashing, indicating Synchronization process is activated. Remember the Intercom unit
must be ready as above mentioned.
· The Camera unit will make one long beeping sound and the power LED stops flashing,
indicating successful Synchronization, while at the same time the Intercom unit's screen will
show up" SYNCHRONIZATION SUCCEED, CH2 SELECTED. PLEASE PRESS MODE TO
EXIT." So, Press MODE button, you can see image instantly with CH2 displayed on screen
showing which channel you are in.
· For matching more additional camera, select Channel 3 or 4 by pressing Channel button
(27) of the Intercom.
· Repeat the above process for 'PAIR' for additional cameras.
· Use the Channel button (27) to check the pictures from different Cameras.
· Then use Adjustment button (+) (-) to choose "DEL". Then press MODE, the deletion
process completed.
· For Deleting, Push the Channel button (27) at the back for about 3 sec. Press this Channel
button to select the channel to be deleted.
LCD On/Off and Power On/Off (25)
When the switch is in the LCD "off" position (the middle position), the Camera is transmitting
whereas there will be no image shown on the Intercom. The unit is using only a small amount
of power and you can still hear the sound signal from the monitored area. Turn the LCD to
"on" position to view the image again and to "off" position to turn the Intercom off completely.
Talk (21)
To talk to the baby, press & hold the Talk button (21) to talk. The talking volume is adjusted
by Adjustment button (13) on baby unit. After talk, release the Talk button & listen to the baby
sound again. Please note that by pressing Talk button, you can remove all icon symbols
display on screen.
Music (23)
Press the Music button (23) once to play the first lullaby broadcast
Press Music button again to change to second lullaby
lullaby 3. Press again to stop lullaby
selection. The LCD will show from
is adjusted by button (13) on the baby unit. The chosen lullaby will play back non-stop until
you stop it.
2. Press again to change to third
. There are three incorporated lullabies for
1 to 3 to indicate your selection. The music volume
1on the Baby unit.