Security Overview - Airo YXEA03U Manual De Usuario

Cautions

3. Security overview

●
Do not install by yourself. Please entrust professionals or authorize your dealer to
install. If you install by yourself or install improperly, it may cause electric shock or fire
accident.
●
Installation works shall be carried out correctly by referring to this installation manual.
If not, it may cause electric shock or fire accident, etc.
●
Never operate with wet hands or spray water to the product. All these products are
equipped with electrical components, spraying of water may cause severe electric
shock hazard or short-circuit accident.
●
Never touch or adjust safety devices in the equipment. If these devices are touched or
adjusted, it may cause a serious accident.
●
Never open enclosure of equipment to repair without turning OFF the main power
supply.
●
Cables of specified specifications shall be used during wiring, be reliably connected
and avoided from being nipped by enclosure. The terminal connection shall be secured
reliably, and the cables and wiring terminals shall be avoided from being subjected to
any external force, or the wiring would be poor and would cause overheating, fire or
other hazards.
●
During installation, please use the components provided with the equipment together or
appointed components. If any component which is not appointed by our conmpany is
used, it may cause electric shock, fire or other accidents.
●
Please stably install to a place where weight of the machine can be supported fully, or
it may lead to falling of machine body and injury.
●
After the equipment is installed, turn it on to carry out electric leakage test.
●
Do not install in following places, or it may cause fire, machine deformation or faults.
*
Places where oil (including machinery oil) mist and steam drift.
*
Places where sulfide gas drifts (such as in hot spring).
*
Places where there are inflammable gases.
*
Coastal areas and the places where the machine body will be corroded by salt, strong
acid or alkali.
*
Places where the temperature is high or there is open fire, or it may cause heat generator
or fire.
*
Places which are close to the machine generating electromagnetic wave. The
electromagnetic wave may influence remote control system and disturb normal operation
of controller.
*
Places where there is a lot of moisture or that may be wetted. Once water enters into
remote control, it may not only cause electric shock, but also may cause fault of internal
electrical components.
！
DANGER
！
WARNING
19