Redmond RMC-M110A Manual De Usuario página 16

VI. CLEANING AND MAINTENANCE GUIDELINES
Before you start cleaning the device, ensure that it is unplugged and has cooled down. Prior to first use or in order to remove the odor after cooking,
boil half a lemon using BOIL for 20 minutes (pressure cooker mode). Use soft cloth and mild soap to clean.
DO NOT use a sponge with hard or abrasive surface, solvent and abrasive cleaning methods are not allowed.
DO NOT immerse the device in water or wash it under running water.
Clean the housing as necessary.
We recommend cleaning the bowl after each use. The bowl is dishwasher safe. Make sure to wipe the outer surface of the bowl after cleaning to ensure
that it is completely dry before the next use.
We recommend cleaning the inner lid after each use:
1. Open the lid. Find the retaining nut located on the inner side of the lid. Unscrew the nut (by turning it counterclockwise) holding by the lid and carefully
separate the lid from the jointed mechanism.
2. Clean inner surface of the lid and wipe dry.
3. Place the lid back by matching the opening in the center of the lid with the screw on the lever of the jointed mechanism (the lid locking lever must
be on the top), and firmly screw in the retaining nut (by turning it clockwise).
To clean the inner surface of the lid thoroughly, remove the rubber sealing ring and disassemble the steam release valve.
Clean the steam release valve after each use of the device:
1. Remove the steam valve regulator, located on the outer side of the lid by pulling it up.
2. Unscrew the protective cover located on the inner side of the lid.
3. Rinse both parts of the valve with water.
4. Screw the protective cover back on, and fix the steam valve regulator in the pinhole by applying slight pressure.
To clean the shutoff valve on the inner side of the lid wipe it and the rubber sealing ring with a moist sponge or towel.
Clean the rubber sealing ring located on the inner side of the lid as needed: remove the ring, rinse it under warm water and evenly place it back.
Condensation may accumulate inside the collector located on the back of the housing. Pull the condensation collector down to remove it, pour the
water out, and place collector back into place.
16