Empty Dirt Trap [3], Replace Disposal Bag; Replace Filter And Sensor Filter [4]; Changing The Cooling Air Filter - Festool TURBO II M - 8 WP Manual De Instrucciones

Turbo II M
GB
This test may include checks to determine wheth-
er the filter is damaged, the machine is sealed
properly and the monitoring features are function-
ing correctly.
– During maintenance and repair work, all compo-
nents that cannot be cleaned satisfactorily must be
replaced. The old components must be sealed in
impermeable plastic bags prior to disposal in com-
pliance with applicable regulations for this type of
waste.
– Provided maintenance personnel or other persons
in the vicinity are not endangered, the user must
dismantle and clean the machine prior to perform-
ing maintenance work. Appropriate precautionary
measures include decontaminating the machine
prior to disassembly, making provisions for locally
filtered forced ventilation at the location of ma-
chine disassembly, cleaning the maintenance area
and appropriate personal protective equipment.
10.1

Empty dirt trap [3], replace disposal bag

WARNING
Dust may arise when emptying the dirt trap

Wear a dust mask!

Open housing door [3-2].

Pull handle [3-1] forward.
The filter container is raised.

Remove dirt trap [3-3] completely.

Empty dirt trap or close disposal bag carefully so
that dust cannot escape and replace with a new
one.
 Always move the dirt trap back to the front and
push back the handle, otherwise the machine will
not function.
10.2

Replace filter and sensor filter [4]

WARNING
Dust may arise when emptying the dirt trap

Wear a dust mask!

Open housing door [4-3].

Slacken screws [4-1] and remove housing part
[4-2].

Remove vacuum sensor hose [4-6]; press blue
ring on compression fitting and pull hose.

Slacken star-grip screw [4-5] and remove com-
pletely.
26

Remove supply air pipe [4-7].

Pull handle [4-4] forward and remove.
The handle is raised.

Remove filter container [4-8] with dirt trap.

Carefully tap filter into its mounting, put the bag
of the spare filter over the filter flange and in-
sert the filter into the bag during removal. Exer-
cise care when sealing the bag so that no dust
escapes. Observe the regional regulations on
filter disposal.

Carefully remove dust deposits around the filter
mounting using a damp cloth or a suitable mo-
bile dust extractor.

Insert new filter cartridge.
For ATEX turbine secure the ring cable lug of
the discharge lines as in the prior state.

Unscrew central sensor air filter; reach in
through a main filter opening.

Clean compression fitting.

Insert new sensor air filter and tighten by hand.
 Always move filter and dirt trap back to the front
and push back handle, and screw in star-grip
screw, [4-5] otherwise the machine will not func-
tion.
10.3

Changing the cooling air filter

There are cooling air filters at two locations on the
exhaust turbine, which must be replaced if required:
in the control box:
DANGER
Injuries, electric shock or fire

Covers at the frequency converter can only be
removed at least 15 minutes after the system is
switched off.

Ensure proper grounding!

Open control box.

Slacken screws at the bracket of the cooling air
filter [5-1].

Remove filter and replace with a new one.
Under the upper cover:

Switch off device.

Remove upper cover after slackening screw con-
nections.

Slacken screws at the bracket of the cooling air
filter [5-2].

Remove filter and replace with a new one.