Cutting Height Adjustment - Schulz CGE 1000 Manual De Instrucciones

Before operating the lawn-mower, check the following:
• Proper clothing as well as safety eye, hand, foot, head and ear protection is worn, check SAFETY INSTRUC-
TIONS Chapter.
• Before using, always visually inspect to see that the blades, blade bolts and cutter assembly are not worn or
damaged. Replace word or damaged blades and bolts in sets to preserve balance.
• Observe in Figure 9.1 the correct way of fixing the extension cord on the cable support. It will provide you
with more safety and durability to the extension cord and to the machine's plug.
IMPORTANT:
during cutting or could wind around the cutting mechanism. Carefully check the area to be mown for wildlife
such as hedge hogs, frogs etc , and move them to a safe location.

1. Cutting height adjustment

ATTENTION: Before make the adjustment, disconnect the plug from power supply and wait for all moving
parts to stop.
Use the proper cutting height according to the height of grass. The grass height cannot taller than the ad-
justed height. The adjustable height is 20/40/60mm.
1.1 To adjust the front wheel outing height position:
• Turn the mower upside down;
• Pull the wheel axle towards the front of the mower;
• Locate the wheel axle into the desired cutting height adjustment position (Figure 7.8).
Note: Make sure that both front right and left wheel are located in the same cutting height adjustment position.
1.2 To adjust the rear wheel cutting height position:
• Turn the mower on its side;
• Pull the rear wheel axle towards the mower's catcher flap (Figure 7.9);
• Locate the wheel axle into the desire cutting height adjustment position.
Clean the area to be cut before each use. Remove any objects that could be thrown
EXTENSION
FIGURE 7.7
34