Siemens RDJ100 Instrucciones De Funcionamiento página 6

DE
Setting the first switch-on time (first comfort time)
1. Set the programming selector to position A1. The setting for the first
EN
switch-on time flashes.
2. Turn the setting knob counter-clockwise to decrease the time, or
FR
clockwise to increase the time.
3. When the required switch-on time is displayed, move the
programming selector to any other position to confirm your setting.
IT
NL Setting the first switch-off time (first energy saving time)
1. Set the programming selector to position A2. The setting for the first
ES switch-off time flashes.
2. Turn the setting knob counter-clockwise to decrease the time, or
clockwise to increase the time.
PT
3. When the required switch-off time is displayed, move the
programming selector to any other position to confirm your setting.
CS
Setting the second switch-on time (second comfort time)
HU
1. Set the programming selector to position A3. The setting for the
second switch-on time flashes.
PL
2. Turn the setting knob counter-clockwise to decrease the time, or
clockwise to increase the time.
SV
3. When the required switch-on time is displayed, move the
programming selector to any other position to confirm your setting.
FI
Setting the second switch-off time (second energy saving
ZH
time)
1. Set the programming selector to position A4. The setting for the
TR
second switch-off time flashes.
2. Turn the setting knob counter-clockwise to decrease the time, or
EL
clockwise to increase the time.
3. When the required switch-off time is displayed, move the
programming selector to any other position to confirm your setting.
RO
DA
Switch-on and switch-off times are related. When trying to
set a switching time to a time after the next switching time,
NOTE
the latter time will automatically be moved forward
(or backward).
A6V101035986_en--_a / 2017-1-1 Subject to alteration
Setting the comfort temperature
1. Set the programming selector to position
2. The setting for the current comfort temperature flashes.
3. Turn the setting knob counter-clockwise to decrease the
temperature setting, or clockwise to increase the temperature
setting.
4. When the required comfort temperature is displayed, move the
programming selector to any other position to confirm your setting.
Setting the energy saving temperature
1. Set the programming selector to position
current energy saving temperature flashes.
2. Turn the setting knob counter-clockwise to decrease the
temperature setting, or clockwise to increase the temperature
setting.
3. When the required energy saving temperature is displayed,
move the programming selector to any other position to
confirm your setting.
Changing the current setpoint temporarily
1. The current setpoint can be changed temporarily when the
operating mode selector is in the AUTO position and the
programming selector in the RUN position.
2. Turn the setting knob slightly in either direction to display the
current setpoint, then turn it counter-clockwise to decrease the
temperature setting, or clockwise to increase the temperature
setting.
3. This setpoint is maintained until the next switching time. When this
is activated, the hand symbol is displayed.
Setting the temporary comfort temperature
1. Turn the setting knob counter-clockwise or clockwise to adjust the
desired temperature when the operating mode selector is set to
Comfort mode (temporary override of Comfort temperature).
2. The temporary override of the Comfort temperature is cancelled
when the operating mode is changed.
Changing the batteries
1. Get 2 new alkaline batteries type AA, 1.5 V.
2. Within 1 minute: pull out the battery compartment and remove the
batteries, then insert new batteries and replace the battery
compartment.
3. Make certain the old batteries are disposed of properly, in
compliance with environmental requirements.
Energy saving tips without sacrificing comfort
●
Never allow room temperatures to exceed 21˚C
●
Air out rooms for short periods of time only, but properly, with the
windows wide open
Siemens Building Technologies / HVAC Products
.
.
The setting for the