Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
÷
÷
REMOTE CONTROL
4
_
6_
7 j
8 j
10
11
12
13
14
15
16
1. POWER Button
_ Press to turn the TV on. Press again to
turn the TV off.
2. Direct Channe_ Selection
Buttons
(0-9) _ Allows direct
access to any channel.
3. QUmCK VIEW Button
- This button allows you to go back
to the previous channel selected by just pressing the
QUICK VIEW button. Press this button again to return to
the channel you were watching.
4. SLEEP Button _ To set the TV to turn off after a preset
amount of time, press the SLEEP button on the remote
control. The clock will count down 10 minutes each time
the button is pressed in the order of 120, 110, 100, ---
20,
10, 0. After the sleep time is programmed,
the display will
disappear then reappear momentarily every ten minutes to
remind you the sleep timer function is operating. To confirm
the sleep time setting, press the SLEEP button once and the
remaining time will be momentarily displayed. To cancel
sleep time, press the SLEEP button repeatedly until the
display turns to 0.
5. VOL (VOLUME)
'( / ) Buttons _ Press the ) button to
increase, or the ( button to decrease the volume level.
6. MENU Button _ Press to display the On-Screen menu
function.
7. SET-
/ + Buttons _ Press to select the desired setting during
On-Screen operations.
8. RESET Button _ Press to reset the On-Screen picture and
sound adjustments to their factory preset positions. Press to
reset a password in the V-CHIP Password setting mode.
9. TV/AV Button _ Switches between TV and external inputs.
10. CALL Button - When you press this button, the channel
number will appear in the upper right corner of the screen.
Press the button again to remove display from the screen.
11. MUTE Button - To turn off the sound, press this button
once. The TV will be silenced and the symbol "MUTE" will
appear on the screen. The muting feature can be released
by pressing the MUTE button again or one of the VOL
or ( button.
12. OH (CHANNEL)
/.. / v
Buttons-
Press the A button to
change to a higher numbered channel set into memory. Press
the v button to change to a lower numbered channel set into
memory.
13. ENTER Button - Press to enter or select information for On-
Screen operations.
14. AUDIO SELECT Button
_ Switches sound between mono
and stereo when receiving broadcasts in stereo or SAP.
15. 0H.1/2 Button _ Switches between Channel 1 and Channel 2
in the Closed Caption mode.
l&
TV/CAP/TEXT
Button = Press this button to switch between
normal TV and the two Closed Caption modes (captions and
1/2 of full screen text). Closed Captioning will display text on
screen for hearing impaired viewers.
Before
using the remote
control,
batteries
must first be installed.
NOW TO INSTALL
BATTERIES
Use two "AAA" size batteries. The batteries may last
1. Open
the battery
compartment
cover,
approximately
one year depending
on how much the remote
control is used. For best performance,
it is recommended
that batteries
should be replaced
on a yearly basis, or when
the remote operation
becomes
erratic.
Do not mix old and
new batteries
or different
types.
2. InstalI two "AAA" batteries
(not supplied).
3, Replace the battery compartment
cover,
BATTERY PRECAUTIONS
These precautions
should be followed when using batteries
in this device:
o Use only the size and type of batteries
specified.
o Be sure to follow the correct polarity
when installing
the
batteries
as indicated
in the battery compartment.
Reversed
batteries
may cause damage
to the device.
o Do not mix different
types of batteries together
(e.g.
Alkaline
and Carbon-zinc)
or old batteries with fresh ones.
o If the device
is not to be used for a long period of time,
remove the batteries
to prevent damage
or injury from
possible
battery
leakage.
o Do not try to recharge batteries not intended to be re-
charged;
they can overheat
and rupture
(Follow battery
manufacturer's
directions).
5
÷
3R20521A-E
÷
27/4/04,
14:05
Publicidad
Tabla de contenido
