3
Using the DVR-4HD
3.1 Recording Videos
3.1.1 Record videos while driving
When the vehicle engine starts up and the Automatic Record function is enabled, the device automatically
turns on and starts recording.
The touch panel function is not ready yet within 2 seconds upon the Auto Recording start.
Recording will automatically stop when the engine is switched off, or touch
manually.
Note:
1. On some cars, the recording will continue when the engine is switched off. If this happens, please manually
turn off the cigarette lighter or remove the car adapter from the cigarette lighter.
2. It can be configured to save a video file for every 3 or 5 minutes of recording. Please refer to Video
Duration (4.2).
3. The device saves the recording in the memory card. If the memory card capacity is full, the oldest file in the
memory card is overwritten.
3.1.2 Emergency Recording
Start the Emergency Recording, do the following:
1.
During video recording, touch
emergency recording mode, the "Emergency" message
will be shown immediately on the lower left corner of
the screen, and the recorded file will be protected.
2.
Touch
again, to halt the recording.
Note:
1. If the Collision Detection function is enabled and a collision is detected, the device will automatically
trigger the emergency recording. Please refer to Collision Detection (4.2).
2. The emergency recording file is created as a new file, which will be protected to avoid being overwritten
by normal cycling recording. 8G (or above) memory card can save up to 10 emergency video files. The alert
message of "Emergency files are full" will pop up on the screen when the emergency recording files are full,
and the oldest emergency file will be automatically deleted when a new emergency recording file is created.
to enter
EN • 15
to stop recording
DVR 4HD 2015 V1.1 12/4 MultiLing
© copyright 2015