Remote Control - cecotec CONGA 3090 Serie Manual De Instrucciones

4.2. REMOTE CONTROL

1. Schedule
2. Spot cleaning
3. Back home
4. Time
5. Manual control
6. On/Pause
7. Power levels (Turbo/Normal/Eco)
8. Edge mode
• The following operation and modes can be activated from the remote control.
MODES
The first time the robot is operated, it will map and memorize the whole house by means
of its laser before starting the cleaning cycle.
Note: make sure the light indicator is lit up in blue before starting cleaning, indicating it is
activated. If it is not, press any button on the remote control to wake it up.
1. AUTO mode
Press on the remote control for it to start cleaning automatically in zig-zag, recognizing
which areas it has cleaned and which ones it has not.
The robot will plan the cleaning route automatically as it is cleaning. If during this mode
the robot is directed manually, it will re-plan the route and could repeat already-cleaned
areas. In order to ensure efficient cleaning, do not operate it manually during auto mode
cleaning.
If the battery is low during the cleaning cycle, the robot will
smartly return to the charging base automatically and, once
it is fully charged, it will resume the cleaning from the same
point, offering a high-efficiency cleaning.
During the cleaning, the robot will make a brief stop to
evaluate the area and plan the cleaning route (this stop will
vary depending on the house conditions).
Note: it is suggested to use the auto mode when cleaning carpets.
1
2
3
ENGLISH
4
5
6
7
8
25