cecotec CONGA 3090 Serie Manual De Instrucciones página 26

ENGLISH
2. Spot-cleaning mode
While the robot is paused or in standby mode, press
on the remote control to activate Spot-cleaning
mode. The robot will clean within a 2*2 space. This
mode is commonly used to clean floors where dust is
concentrated.
3. Edge mode
Press the
start cleaning under this mode. It will automatically
start cleaning along walls, around furniture etc.
Note: press POWER button to switch between the 3
modes: Turbo/Normal/Eco
4. Back-home mode
Press the button on the remote control to send the
robot to the charging base. This mode can be activated
during any other cleaning cycle and the robot will
automatically return to the charging base and stop the
cleaning process.
The robot will take the shortest route back to the
charging base thanks to its map memorizing and the
smart back-home function.
When a cleaning cycle has been completed or the robot's battery is low, the robot will
also return to the charging base to avoid running out of battery.
Warnings:
• Remove the water tank from the robot before charging it.
• If there are obstacles in the room being cleaned, the robot might not be able to reach
the charging base. In this case, take the robot manually.
PAUSE
While the robot is operating, press
pause it and press
SLEEPING
The robot will automatically enter sleeping mode after 5 minutes of no operation. Press
26
on the remote control for the robot to
to resume cleaning.
on the App, the remote control or on the robot to