Connections; Power Cord - Kenwood SW-21HT Manual De Instrucciones

Connections

If your amplifi er or receiver outputs only the L/R
separated, line-level signals, it is required to use an
adapter for synthesizing the L and R signals (not
provided) in order to connect Subwoofer to such an
amplifi er or receiver.
• In case an associated system component is
connected, also read the instruction manual of the
component.
• Be sure to insert all connection cords securely.
connections are imperfect, the sound may not be
produced or noise may interfere.
¤ CONNECTION PRECAUTIONS
Do not connect the power cord plug into the power
outlet until all other connections are complete.
Before unplugging a cord or cable from the unit,
always sure to set the POWER switch to OFF and
unplug the power plug from the power outlet.
Amplifi er or Audio Video control center
Pin-plug cord
          A ' P I N K U J A U K F G  K P F D 
¤ CAUTION
Simply setting the POWER switch to OFF does
not shut down the power supplied to the unit
completely. To isolate this unit completely from the
power supply, it is necessary to unplug the power
cord from the power outlet.
To shut down the power supply to the unit
immediately in case of an emergency, connect the
power plug to an easily accessible power outlet.
Mains plug is used as the disconnect device, it
shall remain readily operable and should not be
obstructed during intended use.
To AC wall outlet
• Insert the plug fi rmly all the
way into the AC wall outlet.
¤ Power cord
Two types of power cords are provided.
Select the one designed for the country in which
this unit is used.
5
English