System Requirements - i-tec C31HUBMETAL403 Manual De Instrucciones

EN Quick Start /USB-C HUB 4 Port
INTRODUCTION
The HUB offers 4 USB 3.0 ports with the Plug & Play function and standard
USB charging. The HUB does not require installation of drivers. You will
just connect it by the USB-C cable to your computer and immediately
you can start using it. The HUB has a built in overcurrent protection of
your computer in case of short connection on the peripheries. Thanks to
its compact dimensions and low weight it is an ideal companion to your
notebook when traveling.
INSTALLATION IN WINDOWS 7 / 8 / 8.1 / 10 AND HIGHER, MAC OS,
LINUX AND OTHERS
The HUB is installed automatically, no need install drivers. Plug the HUB via
USB-C 3.1, gen. 1 cable into available USB-C port of your notebook / PC and
follow the on-screen instructions. The HUB will be installed and displayed in
Device manager as "Generic USB Hub" and "Generic USB SuperSpeed Hub".
CHARGING
The HUB supports charging of the connected USB mobile equipment such
as smartphones (including iPhone and Samsung phones), e-book readers,
multi-media players, GPS navigators, and tablets (e.g., Asus, Toshiba,
GoClever, Prestigio, Emgeton, Sencor). Using the original cable connect the
equipment to be charged to the USB port of the HUB.

SYSTEM REQUIREMENTS

Hardware requirements
Notebook / PC with one available USB-C port
Operating system
Windows 7 32/64bit, Windows 8 32/64bit, Windows 8.1 32/64bit, Windows
10 32/64bit, macOS, Linux, Android 6 or higher, Chrome R51 and higher
8