Transmitting - Kenwood TK-760G serie Manual De Instrucciones

TRANSMITTING

Note: You can also transmit using a TK-762G/ TK-862G transceiver.
1 Press and hold the PTT switch.
2 Enter the code of the transceiver you want to call or enter a Group code on
the keypad.
• Be sure to enter the ID or Group code, followed by the Intermediate code of the
transceiver you want to call. If desired, you can also enter a message code of up to 5
digits.
• If desired, you can send codes the same way you make DTMF calls {page 12}. Both
manual methods can be used or you can store codes in memory, then dial them from a
memory location.
• TK-760G/ TK-860G only: "CALL" appears on the display and the LED indicator lights
red.
3 Use the transceiver the same as in a regular call; press the PTT switch to
transmit and release it to receive.
• When you release the PTT switch, squelch turns OFF and the LED indicator flashes
orange (depending on dealer programming). When you receive a signal, the LED
indicator alternates between green and orange. When the signal drops out, the LED
indicator flashes orange again. If no signal is received for a pre-determined time,
squelch turns back ON.
• Pressing the key programmed as Monitor at any time will turn the squelch back ON.
16