Features; Assembly - RIDGID R8694220 Manual Del Operador

FEATURES

PRODUCT SPECIFICATIONS
Dual Power ....................... 18 Volt Battery/12 Volt Adaptor
LEDs ................................. 25 Watts Total (6.25 Watts/LED)

ASSEMBLY

WARNING:
Do not use this product if it is not completely
assembled or if any parts appear to be missing or
damaged. Use of a product that is not properly and
completely assembled or with damaged or missing
parts could result in serious personal injury.
If any parts are damaged or missing, please call 1-866-539-1710 for assistance.
OPERATION
WARNING:
Do not direct the light beam at persons or animals
and do not stare into the light beam yourself (not
even from a distance). Staring into the light beam
may result in serious injury or vision loss.
WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
The use of attachments or accessories not
recommended can result in serious personal injury.
NOTICE:
Operate in a well ventilated area. Do not block
vents. Keep them clear to allow proper ventilation.
Light Output ...............................2,500 Lumens (Maximum)
Runtime ......................................................... Up to 5 hours
WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended
for use with this product. Any such alteration
or modification is misuse and could result in a
hazardous condition leading to possible serious
personal injury.
APPLICATIONS
You may use this product for the purpose listed below:
 To illuminate distant objects and areas requiring additional
light
INSTALLING BELT HOOK
See Figure 1, page 7.
 Align belt hook with right or left side screw hole.
 Install screw to secure belt hook in place.
INSTALLING/REMOVING BATTERY PACK
See Figure 2, page 7.
 Align the raised rib on the battery pack with the groove
inside the light cannon, then slide the battery pack into
the light cannon.
 Make sure the latches on each side of the battery pack
snap into place and that battery pack is secured in the
product before beginning operation.
 Depress the latches to remove the battery pack.
NOTE: This product is designed to be powered by either
a RIDGID 18 Volt battery pack or 12 Volt power source as
described in this manual.
If the light flashes during operation, try recharging and
reinstalling the battery pack.
For complete charging instructions, see the operator's
manuals for your battery pack and charger.
4 - English