Features; Assembly; Operation - RIDGID R8694221 Manual Del Operador

FEATURES

PRODUCT SPECIFICATIONS
Dual Power ..............................................18 Volt Battery or
LEDs ................................... 24 Watts Total (0.5 Watts/LED)

ASSEMBLY

WARNING:
Do not use this product if it is not completely
assembled or if any parts appear to be missing
or damaged. Use of a product that is not properly
and completely assembled or with damaged or
missing parts could result in serious personal
injury.
If any parts are damaged or missing, please call 1-866-539-1710 for assistance.

OPERATION

WARNING:
Do not direct the light beam at persons or animals
and do not stare into the light beam yourself (not
even from a distance). Staring into the light beam
may result in serious injury or vision loss.
WARNING:
Do not allow familiarity with tools to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this tool.
The use of attachments or accessories not recom-
mended can result in serious personal injury.
APPLICATIONS
You may use this tool for the purpose listed below:
 General illumination of most work area spaces
120 Volts, AC only, 60 Hz
6 – English
Light Output ...............................2,500 Lumens (Maximum)
Runtime ......................................................Up to 14 hours*
*Lowest setting using 5.0 Ah battery
WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended
for use with this product. Any such alteration
or modification is misuse and could result in a
hazardous condition leading to possible serious
personal injury.
NOTICE:
This product is designed to be powered by either
a RIDGID 18V battery pack (DC mode) or by elec-
tric power (AC mode). Either power source can
be used by installing an approved battery pack or
power cord into the product as described in this
manual.
INSTALLING/REMOVING BATTERY PACK
See Figure 1, page 10.
 Rotate the adjustable head forward as needed to gain
access to the battery port.
 Insert the battery pack into the product as shown.
 Make sure the latches on each side of the battery pack
snap into place and the battery pack is secured before
beginning operation.
 Depress the latches to remove the battery pack.
WARNING:
Always remove battery pack or unplug extension
cord from your product when you are assembling
parts, making adjustments, cleaning, or when not
in use. Removing battery pack or unplugging ex-
tension cord will prevent accidental starting that
could cause serious personal injury.