Checklist Before Each Use; 15.3.1 Checking The Fuel Tank Level; Operation - Zipper Maschinen ZI-MOS125 Manual De Instrucciones

Desbrozadora móvil
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 33
Fig. D1:
Dismount the black cover by unscrewing
the Phillips head screw with Allen key.
Fig. D2:
Move the cable collet through the holder.
Fig. D3:
Screw the cable collet into threaded
boring so that it stands approx. 5mm
through the boring. You can later the
maximum throttle by adjusting this bolt if
required. If you are not proficient in base
throttle adjustment let this be done by a
person with suitable knowledge and
experience
Trimmer assembly
Fig. F5
Before mounting the trimmer, make sure that the slider (I-2) is in the STOP position.
Screw the trimmer firmly onto the mounting thread, fixing the mounting shaft again. The trimmer does
not require any further assembly steps as the trimming is self-locking due to the rotation and thread
direction
The use of paint thinners, petrol, aggressive chemicals or abrasives leads to material damage
to the surfaces! Therefore use only mild detergents for cleaning!
Clean the machine and remove dirt and dust if necessary.
If the air filter is dirty, blow the filter cartridge from the inside by moving a jet of dry
compressed air up and down. Continue until all dust has been removed. Replace the
air filter with a new one if necessary.
Check the carburettor for external dirt and dust and clean it with dry compressed air if
necessary.
Check the nuts and bolts for tightness. (Screws or bolts loosened by vibrations can
lead to accidents!)

15.3.1 Checking the fuel tank level

1. Screw on the tank cap (sits on the fuel tank).
2. Level check in the form of a visual inspection. If necessary, top up with fuel
3. Close the fuel filler cap tightly after refuelling.
16

OPERATION

Only put the machine into operation after you have read and understood the safety
instructions and carried out the necessary measures before initial commissioning.
ZIPPER MASCHINEN GmbH
www.Zipper-Maschinen.at
ZI-MOS125

Checklist before each use

Observe the safety regulations for fuel control. Filter the fuel during refuelling to
prevent foreign particles from entering the combustion chamber. Wipe up leaked fuel.
with the appropriate octane number (RON 95).
Only work in the moderate speed range during the first 10 operating hours
Moving components still have to adapt to each other. After this period the
motor will reach its maximum power. Non-observance of this instruction
shortens the service life of your machine enormously.
Fig. D4:
Pull the throttle cable out of the cable collet and
hang it into the slot as shown in Figure D4.
Fig. E1:
Plug.
Fig. E2:
Stick the ends of the two plugs together as shown
in Figure E2.
N O T I C E
N O T I C E
N O T I C E
OPERATION
29

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

912003923782 4

Tabla de contenido