Warm Through; Move - Fri-Jado CSD 180 Hot Instrucciones De Manejo

CSD 180 Hot
Install slide:
Insert a slide if the unit has been provided with
a slide holder.
WARNING
Remove the plug from the outlet.
1. Loosen the 7 screws in the ceiling around
the lighting, but do not remove them.
2. Carefully push against the slide holder
until the lighting module cannot slide in
further.
3. Remove the two transparent plastic plates
(A) from the slide holder and take them out
via the bottom of the unit.
4. Place the new slide (B) between the
plastic plates (A) and go through the steps
in reverse order.
3.3.

Warm through

Let the unit warm through for at least half an hour at the highest temperature setting to
allow the metal odour that exudes from it when it is new to burn off.
3.4.

Move

Before moving the unit:
1. Switch off the unit.
2. Remove the plug from the outlet.
3. Let the unit cool off for fifteen minutes.
4. Empty the water tray.
en / 2-VIII
A
B
9123529 / 0712