Problems - Fri-Jado CSD 180 Hot Instrucciones De Manejo

CSD 180 Hot
6.

Problems

WARNING
•
If the problem is not solved by consulting the table below, proceed as follows:
1. Switch off the unit.
2. Remove the plug from the outlet.
3. Contact your supplier/service agency. Make sure you have the following data
at hand: model and serial number.
•
If the lead is damaged, immediately contact your supplier/service station.
•
All windows used in the unit are made of tempered glass. If windows must be
replaced, use the same material.
•
The required electric diagrams are supplied with the manual.
Item
Unit
Unit
Unit
Lamp
Problem
Does not function.
The set temperature is not
reached within half an hour.
The temperature rises too
much.
A lamp is defective.
en / 2-XII
Action
•
Is the plug in the outlet?
•
Is the power supply OK?
Check the fuses and the
earth leakage switch in the
meter cupboard.
•
Are all switches in the
correct position?
•
Close all windows.
•
Check the set temperature.
•
Switch off the unit.
•
Remove the plug from the
outlet.
•
Contact your
supplier/service agency.
•
See paragraph 6.1
9123529 / 0712