Operational Function; To Answer A Call; Making Calls (Manual Selection); Speakerphone - BRONDI BRAVO CORDLESS 2 Manual De Instrucciones

Introduction
When your cordless is in standby mode, i.e. no calls or operations are being made, the heading
HS-1
" " appears on the display (the number identifying the cordless).
• When you receive a call, both handset and base start ringing, the
display, and both the red led on the handset locator button and the big white led on the
phone base start fl ashing.
If your cordless is directly connected to the telephone line (not via PABX) and the Caller
Details Service has been activated by your server, the caller's telephone number (if available)
appears on the display.
• Press the button to answer the call, the symbol
the base red led will fl ash.
• To end a call, press again the
base. The display symbol and the base red led disappear.
• Press button.
• The symbol appears steadily on the display and the base red led starts fl ashing.
• Check that the dial tone is present then key in the number.
• The dialled number appears on the display.
• To end the call, press again the
base.
To activate the speakerphone, press the
pressed the button.
The speakerphone is active if you can hear the caller voice coming from the speaker and can
see the and symbols on the display
the speaker volume). To switch back to standard from a spekerphone call, just press briefl y the
button.
• When handset is idle key in up to 25 digits.
• You can check the digit on the display before starting your call.
• If you make a mistake, press shortly the
to clear all digits, press and hold the
• When number is checked, press the
• At this point digits are selected and dialled.
• To end the call, press the
Note: If you have a PABX connection you need to pause for a few seconds between dialing the
system code and the actual phone number.
To pause, press the
BRAVO CORDLESS-2-lingue
6. O
PERATIONAL FUNCTION

6.1 TO ANSWER A CALL

button, or alternatively replace the handset back in the

6.2 MAKING CALLS (MANUAL SELECTION)

button or alternatively replace the handset back in the

6.3 SPEAKERPHONE

button when the handset is idle or after having
(hold repeatedely the Volume button to adjust

6.4 PRE-SELECTION

DEL
button to clear digits one by one from the display;
DEL
button.
button to start the call.
button again, or replace the handset back in the base.
button and a dash "-" will appear on the display.
11
11
symbol appears on the
will come up steadily on the display and
6-09-2005, 16:09