Accessories - Hilti DX 460 Manual De Instrucciones

Magazine
MX 72
Fastener guides
Ordering designation
X-460-F8
X-460-F8N15
X-460-F8N10
X-460-FBCW
X-460-F8S12
X-460-F8SS
X-460-F10
X-460-F10SS
X-460-FIE-L
X-460-FIE-XL

Accessories

Ordering designation
X-SGF8
X-460-SGMX
X-460-STAB
X-460-TIE-L
X-460-TIE-XL
X-EF adaptor
X-460-B
X-460-WH23/36
X-PT 460
Pistons
Ordering designation
X-460-P8
X-460-P8W
X-460-P10
X-460-PIE-L
X-460-PIE-XL
X-460-PKwik
Cartridges
Ordering designation
6.8/11 M green
6.8/11 M yellow
6.8/11 M red
6.8/11 M black
Cleaning set
Hilti spray, flat brush, large round brush, small round brush, scraper, cleaning cloth.
Printed: 08.07.2013 | Doc-Nr: PUB / 5069834 / 000 / 02
Magazine – For quick and convenient fastenings
Application
Standard
15 mm width for improved accessibility
10 mm width for improved accessibility
For driving X-CW fasteners
Fastener guide for fasteners with a 12 mm steel washer – higher pull over values
Spall stop for 8 mm studs – reduces spalling
For 10 mm studs and nails
Spall stop for 10 mm studs – reduces spalling
For driving XI-FV and X-IE insulation fasteners up to 140 mm.
For driving XI-FV and X-IE insulation fasteners up to 200 mm.
Application
Splinter guard for the X-460-F8 standard fastener guide
Splinter guard for the X-460-MX72
For the X-460-F10 fastener guide
Replacement nosepiece for the X-460-FIE-L fastener guide (25–140 mm)
Replacement nosepiece for the X-460-FIE-XL fastener guide (25–200 mm)
X-EF adaptor for stabilizing the tool perpendicular to the work surface and for reduc-
ing concrete spalling when fastening the X-EKB and X-ECH (only with X-460-F8 fas-
tener guide)
Rubber buffer – protects the fastener guide when the tool is used incorrectly
Washer holder – For fastening 23 and 36 mm steel washers with the magazine. The
washer holder can be mounted on the magazine.
Pole tool extension – Extension system for various ceiling application
Application
Standard piston
Special piston with tapered tip for over-driving nails in wood (driving head beneath
surface)
10 mm piston – For fastening M 10 / W10 studs
Piston for driving X-IE insulation fasteners using the X-460-FIE-L fastener guide
suitable for insulation thicknesses of 25–140 mm.
Piston for driving X-IE insulation fasteners using the X-460-FIE-XL fastener guide
suitable for insulation thicknesses of 25–200 mm
Piston for driving approved threaded studs using the DX-Kwik technique (predrilling
required)
Colour code
Green
Yellow
Red
Black/purple
Power level
Low
Medium
Heavy
Extra heavy
en
23