JVC KV-CM30 Manual De Instrucciones página 5

10
After adjusting the camera angle, tighten the
retaining screws firmly.
Inspect the retaining screws at times. If they are loose,
tighten them firmly.
11
Fix the camera firmly in position.
Peel off the paper liner from the double-side adhesive tape
on the camera bracket and attach it. After attaching, push the
camera bracket with your finger to ensure close adhesion.
Do not touch the adhesive surface with your hand or peel and
reattach an attached tape, as these will degrade the adhesive
force and may cause the camera bracket to be detached. If
required, secure the bracket on the vehicle body using the
camera bracket clamping screw.
The camera bracket has two holes for the screw. Select one of
them to fit the position of the attachment.
Camera bracket clamping screw
(Φ3 x 5 mm)
Specifications
Camera Unit
Output video
: Wide-angle mirror image (for rearview)
Sensor: 1/4-inch color CMOS sensor
Number of pixels: Approx. 380,000 pixels
Lens
: Wide angle, Focal length f=1.12 mm, F value 2.2
Angles of view
: Horizontal: Approx. 129°
: Vertical: Approx. 104°
Video output: 1.0 Vp-p/ 75Ω
Illumination range: Approx. 0.9 to 100,000 lux
Iris system: Electronic iris
Scanning system: Interlace
Synchronizing system: Internal synchronization
Dimensions (WxHxD): 23.4 x 23.4 x 23.9 mm
Weight: Approx. 21 g (without cable)
General
Operating voltage: 14.4V (9.0 V – 16.0 V)
Max. current consumption : 60 mA
• Mirror image means that the video image inverts the left
and right just like the image seen on the rearview mirror or
a side mirror.
• Specifications subject to change without notice.
5
|
ENGLISH