Publicidad
M.-Nr. 10717801
da
en-US
Flow meter module 7 installation instructions
Reason: This module is required for connecting flow meters to the washing machine.
Parts included
Quantity Mat. no.
Designation
1
EZL 235 electronic, module 7
4
Spacer
1
MFM 1-4-5 coding plug
1
"N1-1, N1-16 L, N" wiring harness
1
"N1-1, N1-16 bus" wiring harness
1
"1N1-16, 2N1-16 L, N" wiring harness
1
"1N1-16, 2N1-16 bus" wiring harness
1
"1N1-16, X3-4" wiring harness
1
Brown connecting wire, 90mm
1
Blue 6-pin screw-terminal strip
1
Orange/gray 8-pin terminal strip
1
Module mounting bracket
2
Fixing bracket for module mounting bracket
6
Raised-head screw, CEM 6 x 12
1
Wiring diagram
Danger due to incorrectly carried out service and repair work
WARNING
Danger due to incorrectly carried out service and repair work.
There is a risk of serious damage, injury and even death if service and repair work is carried out incorrectly.
A
Service and repair work should only be carried out by a suitably qualified electrician with specialist training,
knowledge and experience.
A
All appropriate safety regulations must be taken into account.
A
Read the technical service documentation (TSD) before starting service work.
Risk of cuts
CAUTION
Components are sharp.
Risk of cuts.
A
Protective gloves should be worn and the edge protection, mat. no. 05057680, should be used.
Installing flow meter module 7 as the first module
A
Remove the machine lid; see the model-specific TSD.
A
Secure the module (1) with spacers (2) onto the crossbar; see Fig. 1.
A
Install the terminal strip (3) in the pre-punched holes on the crossbar. See Fig. 1.
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
13 von 30
16.03.2018
Publicidad
