Publicidad
18 von 56
A
Place rubber mat supplied on the machine lid and align it with the edges of the machine lid with x = 60.5 mm and Y
= 31 mm.
This serves as the drilling template, see Fig. 5.
A
Drill 6.5 mm diameter holes, see Fig. 5.
A
Drill a 3 mm diameter hole, see Fig. 5.
A
Drill a 30 mm diameter hole, see Fig. 5.
A
Open the front panel of the payment system.
A
Fix rubber mat over the pre-drilled holes.
A
Secure payment system to machine lid using fixing materials supplied.
A
Draw the connection cable through strain relief (10), see Fig. 6.
A
Connect cable to the 7-pole plug in the machine.
An adapter may be required for payment systems C4065 and C4070. For more information see information sheet
"Connection information for C4065/C4070" payment systems supplied. The adapter must then be secured to the
wiring harness with cable ties.
A
For C4065 and C4070 disconnect bridges on plug in the machine in accordance with the information sheet.
PT7251, PT7331, PT8251, PT8251 COP, PT8253, PT8255, PT8331, PT8331 COP, PT8333, PT8335, PT8257, PT8337
For safety reasons the connection cable must not exceed 2.5 m in length.
A
Place rubber mat supplied on the machine lid and align it with the edges of the machine lid with x = 60.5 mm and Y
= 31 mm.
This serves as the drilling template, see Fig. 7.
A
Drill 6.5 mm diameter holes, see Fig. 7.
A
Open the front panel of the payment system.
A
Fix rubber mat over the pre-drilled holes.
A
Secure payment system to machine lid using fixing materials supplied.
A
Open cable strain relief (11) in rear panel, see Fig. 8.
A
Feed connection cable (12) through strain relief, see Fig. 8.
A
Connect coupling (4) to the 7-pole plug in the machine, see Fig. 8.
PW6107, PW6137, PW6167, PW6207
For safety reasons the connection cable must not exceed 2.5 m in length.
A
Place rubber mat supplied on the machine lid and align it with the edges of the machine lid with x = 60.5 mm and Y
= 31 mm.
This serves as the drilling template, see Fig. 9.
A
Drill 6.5 mm diameter holes, see Fig. 9.
A
Open the front panel of the payment system.
A
Fix rubber mat over the pre-drilled holes.
A
Secure payment system to machine lid using fixing materials supplied.
A
Push perforation (1) out of the top of the back panel, see Fig. 10.
A
Feed the connection cable into the machine via this new hole.
A
Connect cable to the 7-pole plug in the machine.
A
Secure the connection cable to the top of the back panel with the strain relief.
21.12.2017
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
M.-Nr. 05719362
Publicidad
