M.-Nr. 05719362
A
Connect the cable to the 7-pin plug in the machine.
An adapter may be required for payment systems C4065 and C4070. For more information see the supplied
information sheet, "Connection information for C4065/C4070 payment systems". The adapter must then be secured
to the wiring harness with cable ties.
A
For C4065 and C4070, disconnect the jumpers on the plug in the machine in accordance with the information sheet.
PT 7251, PT 7331, PT 8251, PT 8251 COP, PT 8253, PT 8255, PT 8331, PT 8331 COP, PT 8333, PT 8335, PT 8257,
PT 8337
For safety reasons the connection cable must not exceed 2.5m in length.
A
Place the supplied rubber mat on the machine lid and line it up with the edges of the machine lid with X = 60.5mm
and Y = 31mm.
This serves as the drilling template; see Fig. 7.
A
Drill 6.5mm diameter holes; see Fig. 7.
A
Open the front panel of the payment system.
A
Line up the rubber mat over the pre-drilled holes.
A
Secure the payment system to the machine lid using the supplied fixing materials.
A
Open the cable strain relief (11) in the rear panel; see Fig. 8.
A
Feed the connection cable (12) through the strain relief; see Fig. 8.
A
Connect the coupler (4) to the 7-pin plug in the machine; see Fig. 8.
PW 6107, PW 6137, PW 6167, PW 6207
For safety reasons the connection cable must not exceed 2.5m in length.
A
Place the supplied rubber mat on the machine lid and line it up with the edges of the machine lid with X = 60.5mm
and Y = 31mm.
This serves as the drilling template; see Fig. 9.
A
Drill 6.5mm diameter holes; see Fig. 9.
A
Open the front panel of the payment system.
A
Line up the rubber mat over the pre-drilled holes.
A
Secure the payment system to the machine lid using the supplied fixing materials.
A
Push the perforated disc (1) out of the top of the back panel; see Fig. 10.
A
Feed the connection cable into the machine via this new hole.
A
Connect the cable to the 7-pin plug in the machine.
A
Secure the connection cable to the top of the back panel with the provided strain relief.
PW 413, PW 418, PW 811, PW 814, PW 818
For safety reasons the connection cable must not exceed 2.5m in length.
A
Place the supplied rubber mat on the machine lid and line it up with the edges of the machine lid with X = 60.5mm
and Y = 31mm.
This serves as the drilling template; see Fig. 11.
A
Drill 6.5mm diameter holes; see Fig. 11.
A
Open the front panel of the payment system.
A
Line up the rubber mat over the pre-drilled holes.
A
Secure the payment system to the machine lid using the supplied fixing materials.
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
25 von 56
21.12.2017