Operating Instructions - DeWalt DXAM-2260 Manual Del Usuario

In Canada , the use of a temporary adapt Or is not permitted by the Canadian
Electrical code. Make sure that the appliance is connected to an outlet having
the same configuration as the plug. No adapter should be used with this
appliance.
WARNING: This product can expose you to chemicals including
lead which is known to the State of California to cause cancer and
birth defects or other reproductive harm. Wash hands after
handling. For more information go to
www.P65Warnings.ca.gov/products.
SAVE THESE INSTRUCTIONS

OPERATING INSTRUCTIONS

WARNING:
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,
DO NOT USE THIS AIR MOVER WITH ANY SOLID-STATE SPEED
CONTROL DEVICE.
Follow these instructions to operate your air mover:
• Unpack air mover from carton.
• To use your unit, place the unit in the area most suitable for your
application. Several factors need to be considered; the unit must be
placed close enough to an AC outlet to be plugged in, there must be
a minimum clearance of two feet from either side of the unit to allow
for proper air flow, and the unit should not be placed where it can
become a tripping or safety hazard.
• Place unit in the proper operating position for your application.
Refer to the Operating Positions section in this manual.
• To use multiple air movers, refer to the Multiple Air Mover
instructions in this section.
• Plug unit into the wall.
• Turn unit on and select air speed by turning the switch, located
near the top handle, clockwise.
• When your drying job is completed, turn the unit off and follow
the directions for Storage in this manual.
Multiple Air Movers Operating
• Your unit comes with receptacles for the use with multiple units.
To use this feature, position the first air mover following the
instructions listed above in this section. This unit may be turned
on while connecting multiple units.
• Plug the second unit into one of the receptacles on the first unit.
Place the second unit in the operation position and the area most
suitable for your application. The second unit may be turned on at
this time.
• A third unit may be plugged into the remaining receptacles on
the first unit or plugged into one of the receptacles in the second
unit. The third unit maybe turned on at his time.
• If desired, follow the same steps to add more units. (totally not more
than 5 units with the main unit include)
• The receptacles on the unit are equipped with a circuit protector
(Figure 1) that will shut off power to the unit should the receptacles
become overloaded. If this happens, move the switch to the off
position on the unit and any units connected to it. Press the reset
button located above the receptacle; then turn the unit on and
any units connected to it.
6